Search results

I have a front and rear 2.5 top loaders, make offer.

Reduced Price....12K.

Ok....the details: 106" stretch, competition cut, sniper fab panels 4.0 Fuel Injected High Output Motor, Automatic Transmission (999), NP 231 w/Terra Low and SYE, Hardtop, Full Hard Doors, Hard Half Doors & Bikini, Prelude Bucket Seats (driver electric), Alpine CD/MP3/Ipod, Alpine 500w, Alpine...

Bump

TTT

Bump

Going to miss it when it's gone!

Your right Caleb, the intent of the title was to attract attention to the thread. Mission accomplished! The companies listed were solicited by the Alliance for support and in some cases may be misrepresented. The dissemination of this information to our forum has promoted awareness and...

Here's your list of Outdoor Businesses NOT to support. They signed on specifically to remove OHV access to 1.4 Million acres in Moab In a letter written to the President to encourage a 1.4 million acre National Monument in Moab Utah. Here is a link to the letter from the Outdoor Alliance...

I have a couple 120deg dies for the pro-tool 105 that I would sell for alot less than new. PM for a number if your interested.

@ RockTaco, making a few sacrifices to speed up the Jk build!

Midnight has tube, tabs etc...

I have a front and rear complete assembly, no modifications located in Sandy. $1800

Looking for a Dana 60 front driver drop. Will negociate with possible trade for my HP Dana 44 (ARB, 538's)

Thanks Black ZJ, hope to see you in Moab then, I will hitting it up alot!

Thanks Cody for the locations. Dusty Bronco, I'm located accross from the highschool on E Center. I tried to look up your location on the map and it appears to be a residence. Not sure if you run shop there?

I'm new to the area, just moved to Kamas from Folsom Ca. for a bridge job. I'm bringing my crawler in a few weeks hoping that the snow is gonna be melting soon :/ I know that Moab isn't too far away and was wondering if there is a trail system close by that would be fun in a rig that is built...