97 Taco project SAS

Status
Not open for further replies.
Post 37 in my build thread shows how they shouldn't be. Everyone had told me that with no weigh on the spring my shackle should be straight up and down. If they are over 90degrees meaning that they are forward of 90 than suppsoedly they may invert when fully flexed and then a load put back on them. however when I installed my new springs they were about 80 degrees forward. Post #73 shows how they were at first. After the springs having settled they are perfect.
 
littlemoabtrip009-1.jpg

littlemoabtrip008-1.jpg

zero weight on the springs

littlemoabtrip010-1.jpg

littlemoabtrip006-1.jpg

littlemoabtrip007-1.jpg

littlemoabtrip013-1.jpg
 
Last edited:
Looks good. Shackle angle looks good. What length shackles are those.Thats things a monster. You going to run 44" tires or something? I am running 3" tg's and my truck is a helluva alot heavier and I clear 37's just fine.
 
Last edited:
bumper

Yeah, Im waiting to put my 35"s on and then trim the bumper alittle. The 37"s are my buddys i borrowed for mock up Im hoping to weld on a trail gear winch mount and build a bumper off of it.



shackle angle
littlemoabtrip036.jpg


littlemoabtrip035.jpg
 
Last edited:
got the rear all done with 63" chevys and mounted my 35" MT tires today
littlemoabtrip038.jpg

littlemoabtrip037.jpg


jacked up the opposite side tires to see how good it will flex:) o yeah it will be a wheelin machine. :)
littlemoabtrip040.jpg
 
Status
Not open for further replies.
Back
Top