can someone help me with .cdr?

[corbin.black]

Hello all, Im new the RME so if this is in the wrong section, I apologize.

I need some help with .cdr files.. I have never used them before.
I dont know how to view these files or if I even can. I had someone send them to me so I could have the design cut by someone else with the proper machine. It will then be welded into a winch cradle for my jeep.

Im guessing someone on here has the ability to cut the design for me but I have no idea who. Someone please point me in the right direction! Im located in Price utah but have no problem traveling to the SLC area to get the design cut. Thanks fo the help!

-Corbin

 

[UNSTUCK]

Contact Ilean here on the board. He should be able to help you with cutting. I was under the assumption that most of these files needed to be .dxf, but I may be wrong. Carl will know for sure.

 

[I Lean]

That's usually a Corel Draw file. I use Inkscape to open those, and convert them into something more usable for cutting. If you want to Email the file to me I can tell you if I'm able to open/convert it, and if so give you a price on cutting. I'll PM you my Email address....

 

[corbin.black]

PM/e-mail sent. Thanks!

 

[UNSTUCK]

Not bad Carl. One minute later...your nose must have been itching.