Custom Wheels

[a4t1rat]

Hey guys... anybody out there know where I can get some wheels made / modified? I have a F450 and I need two rear wheels with 1" more offset. It looks like you could cut out the centers, turn them around and I would get about one more inch. I am hoping some one fairly local.
Thanks

 

[Gravy]

wheel spacers would probably be cheaper. Just an idea

 

[Chevycrew]

More backspace... would bring them in, wheel spacers would be opposite of what he wants to do.

 

[a4t1rat]

Wheel spacers would move the outside wheel out.. I need to move the inside wheel in one inch towards the center of the truck. Also its a 10 lug pattern and I have not seen any spacers for this. The truck is a 2009 F450 with the dana 110 rear end.
Thanks

 

[Greg]

Are the wheels steel? If so, it would be fairly easy to cut the welds out of the center and re-weld the centers 1" further out, making more backspacing.

 

[Gravy]

More backspace... would bring them in, wheel spacers would be opposite of what he wants to do.

ah should have read better

 

[a4t1rat]

Are the wheels steel? If so, it would be fairly easy to cut the welds out of the center and re-weld the centers 1" further out, making more backspacing.

Yes this is what I need... I just need to find some one that can do them. Do you know anyone around that can? Oh and the wheels are steel.
Thanks

 

[ricsrx]

I have done it but it was for a sand car and never driven on road, so Im really not sure how well it turned out for ballancing and higher speeds that it would see on road.

 

[Jesser04]

Stock 19.5 wheels? If you don't mind me asking wha are you doing that requires this?

 

[a4t1rat]

I am going to run a wider tire on these wheels and I want to get more tire seperation. I would rather move the inside wheels in and keep the tires under the fender. I know I can have Stockton wheel make me new wheels but it just seem like there should be a shop around here that can just move the centers.

 

[UNSTUCK]

I know I can have Stockton wheel make me new wheels but it just seem like there should be a shop around here that can just move the centers.

I think any shop could do it. I've seen it done a few times. I know there are a lot of people that could do a great job of it. The problem is liability.

I can plasma cut just fine. I know how to recenter the cut and weld it in. But, say I have an off day of welding.... I like to sleep at night.

 

[a4t1rat]

If you know of any shops where I can start let me know there numbers.
Thanks