General Tech What did you work on Today?

Hickey said:

Added gussets to the rebuilt motor mounts on both sides. This should hold up a lot better than the old setup.
View attachment 177478

Click to expand...

Looks great other than the open square tubing you cropped out of the picture. 😘

kmboren said:

Looks great other than the open square tubing you cropped out of the picture. 😘

Click to expand...

I only send the ugly pics to you personally. 😘

A couple entry handles, while I was welderin’.

Picked up a set of ATX beadlocks off of FB Marketplace a couple weeks ago for a good deal and finally got around to mounting them up. I used my friends tire machine, but it was still a ton of work and almost 4 hours of my life that I will not get back. Since these are -38mm offset, I was able to remove the wheel spacers I put on.

I added Apex valve stems for quick deflate.

I put 12oz of balance beads in each wheel and while not perfect, it will work until these tires get replaced next year. Not a lot of vibration, but if I daily drove it, it would be something I would definitely address.

When I used to run balance beads I had to run like 18oz to get 35-in MTRs to balance on my beadlocks. You should definitely add more if they're still not balancing.