Search results

Summary of swapping a 95 ZJ fuel tank into my 2000 XJ, with the goal of increasing capacity and range. I sourced a clean, used ZJ tank to begin this project. This tank measures out slightly wider and and more square than the XJ tank, which provides a net increase of 3 gallons (20 vs 23)...

Finally got my rear bumper and subframe/hitch mount completed and installed.

Last week I whipped up this mailbox post to replace the aging brick setup that was suffering from structural issues and finally took a tumble. (I slid into it with my Jeep on a snowy winter day about 10 years ago and cracked the base) 4 x 4 x .125 wall tube and some spare plate, plus the...

I contemplated that option, but decided that in order to keep the bumper brackets adjustable to allow for bumper alignment with the body lines, I would also need to fab the said unirail insert brackets (2x4 tube) so that they would be adjustable where they mate up the to bumper, which was more...

My son and his bride need a washer/dryer combo. Gas or Electric on the dryer? Text me the details, please.

Thanks, Mike!

With the bottom side beefed up, I welded on the tail-light fillers and shackle tabs, which tie into the bumper mounts, which then tie into the receiver mounting points on the uniframe. I chopped the center tube out of my stock receiver hitch and replaced the cross tube with a section of...

After toying with several rear bumper designs for my XJ, I finally decided to just go with a JCR DIY bumper that I could modify to suit my goals of a bumper that matches the XJ body lines and the removal of the stock receiver hitch, which hangs down about 4" below bumper height and incorporating...

No father ever wants to hear his daughter utter the words "pleasure package"..........

Ding Ding Ding......winna!

Rally Fighter!

This gem has been in the family since the mid-80's, when my father purchased it from our neighbor, Herb Olsen. It rarely left Morgan County and was used as Herb's primary transportation and as a farm truck. I don't recall ever seeing it travel faster than 40MPH. Prior to my father passing away...

Looks like I'm late to the party, but add me to the standby list.

Just save enough $ for fuel.......

Carl, where did you source the bent steel from? I have a project that I need to complete.......

Soap, water, soak, scrub, shop-vac. Repeat until clean. Do you plan on an epoxy or floor stain treatment?

We picked up a few bottles of sanitizer from Five Wives brewery in Ogden last week. There is a line every day..........supply is low, demand is high, giddyup!!

I've run the "quad-rate" bumpstops on the rear of my XJ for several years. FWIW, I've run Prothane 6 ring coil inserts https://www.prothanesuspensionparts.com/191704 with modified bump plates up front for the last 12 yrs, and they do a great job for the type of wheeling and occasional...

My son is building some JK axles to swap into his XJ, so I have another C-rotation on the horizon.