ALTERED VEHICLES - Continued C. RAISING VEHICLES 1. Check the braking and steering system components. REJECT vehicle when: Braking or steering systems have been altered, modified, disconnected or changed in any manner that may impair the safe operation of the vehicle. 2. Check vehicle lift. (Utah Lift Law Title 41-6a-1631 UCA) REJECT vehicle when: a) Frame height is greater than 24 inches on a vehicle with a GVWR less than 4,500 lbs. b) Frame height is greater than 26 inches on a vehicle with a GVWR of 4,500 lbs. and less than 7,500 lbs. c) Frame height is greater than 28 inches on a vehicle with a GVWR of 7,500 lbs. or more. NOTE: Vehicle must be on a flat surface and unladen for all measurements. Frame height measurement is from the ground to the bottom of the frame and should be taken on the left side of the vehicle under the drivers seat. If the door certification plate has been removed, the vehicle shall be considered to be 4,500 lbs. 3. Check the body lift above the frame. (Title 41-6a-1631 UCA) REJECT vehicle when: Lowest part of body floor is raised more than 3” above top of frame, at mount. 4. Check vehicle for front and rear axle blocks. (Title 41-6a-1630 UCA) REJECT vehicle when: a) Axle blocks have been added to the front axle. b) There are stacked blocks on the rear axle. (The stacking of axle blocks is prohibited.) c) There are stacked frames. Revised June, 2005 27
ALTERED VEHICLES - Continued C. RAISING VEHICLES (Continued) 5. Check vehicle wheel track. (Title 41-6a-1631 UCA) REJECT vehicle when: a) Tire tread protrudes beyond the original fender or fender extenders. NOTE: Fender flares or fender extenders are required to cover both front and rear tires when wheel track extends beyond the vehicle body. b) Spacers are used to increase wheel track width. NOTE: Custom wheel adapters are not spacers. 6. Check for mud flaps. Mud flaps are required on the rear wheels of all vehicles that are altered from their original OEM specifications. This includes the addition of larger tires and suspension lift kits. (Title 41-6a-1633 UCA) REJECT vehicle when: a) Fenders do not cover the top 50% of the tire b) Mud flaps are not present when required. c) Rear mud flaps are not as wide as the tire. NOTE: Mud flaps would not be required if the original fenders cover the top 50% of the tire. From the rear, mud flaps must hang down to the center of the axle.