Search results

Branded is just a generic term. You can have salvage. Rebuilt restored. Flood. Etc. It's printed in the front page of the title. You can Google some examples

Cheap and good with electronic are kinda mutually exclusive IMO

Hey Brian, here's a YZ250 that drilled a hole in itself with the clutch pushrod. Under 100hrs. Go change your oil. A new case half, all new bearings and a piston and it'll be better than new.

I've got a set of 4 They're just dirty. The finish is still nice.

If the carb is leaking fuel into the bottom end it will cause hard starting when it sits. The problem is excaserbated by the fact that the 17-18 carb sits at a slight angle (you can see the position of the notch in the carb boot). This is why some people complained the Mikuni carb was harder to...

Gasoline. Seriously. Old gas. Kills them dead as Round Up. I use it when they grow on my gravel. Problem is the seeds live up to 7 years dormant.

Could the carb be over flowing the bowl and filling the reed block and likely putting fuel in the bottom end. Then somehow the fuel is melting the reeds and reed block?

I'm interested, pending pics.

I've got a set of 6 on 5.5 wheels. I'll snap a pic tomorrow.

I can't imagine being able to over heat the bike enough to melt the tips of the reed case without melting the base. I'm with Paul: Maybe some kinda intake backfire situation. What premix ratio are you running and what jetting? How's the plug look?

🤷‍♂️ I guess it ran good? Couldn't tell because of the straight pipes. Problem is you can't control the rate or direction of expansion. Water expands in all directions with equal force as it freezes. So often it will split the seams on stuff. Even if you get lucky the paint will crack and it'd...

Amazon/ eBay has a single for like $40. That may be your best bet.

Here's the guy that showed up to trade a bike with me today. He said his was nice. Ummm... No thanks. At least he was gracious about knowing what it was.

He wants 4+k worth of trade/ cash for it. You don't want it.

Changed some bearings... The lesson here is sometimes you blast mud into the bearings when you pressure wash.

I'm selling a bike. In my one ad it says no trades. I've gotten seperate offers for a busted A4 AND a busted 330xi AND a busted 1998 CR250r. Say what you will about millennials... these people have got balls. Haha

Have you watched the Bonnie episode of "Roadkill?" It's Goooood

225 miles Home by 4. That was a fun ride! Chalk Creek to the armpit was awesome. Royal street in PC is always good. The tight corners in Pine Canyon where incredible Pizza in Midway at Cafe Galleria was delicious! Cascade Springs Rd. was especially good too. Chad and I even got a tiny bit of...

We'll see you all tomorrow morning! 9am far east Hogle Zoo parking lot. Depart at 9:30am

Torque wrench will get you close. Like Derek said if there's corrosion it throws it off a little. I like to listen and get them to all have the same pitch when I tap them. You can ziptie a sharpie to the fork leg to get an idea if your wheel is out of round too.