Search results

That's surprising. Mine without doors and a windshield, but with a doubler and heavy steel rockers and steel quarters and steel beadlocks and swampers and 14 gallons of gas is only 4180. I would think coilovers and AL links would weigh less than heavy square links, coils and shocks, but...

Good golly Jesse give me a break.... Reality TV man... Let's not start a "Critical Analysis of McGyver" thread next... I hear Baby Seal tears cure cancer, if only we could go back to clubbing them...

A review I read showed the HF torque wrenches to be within .01% of the Snap-On stuff. Good enough for me. The biggest deal is always remembering to loosen them after each use to prevent sag on the spring.

I wondered what happened Chad. By the way that was me yelling for you to hurry up when I passed you in the pits and I was only joking! LOL. I was pretty surprised when you came cooking past me about 10 miles later. You were hauling the mail.

Mine does that when it starts really really cold for about 15 seconds. Goes away when it warms up. And in spring.

Thanks dude!

I liked this the first time I saw it. I loved it when I watched it again.

I tried soaking the carb in 50% Pine Sol/ 50% water and then ammonia in the tank started on Friday and just pulled the carb out and tank out. I think similar results. Both look pretty good. I'm about halfway through reassembly. These are just to help me remember what jets are in it. 35...

nice

I'm helping a friend fix his trail 90 for his dad. Check this "leaking tire fix" yup that's epoxy around the valve stem.... and here's the carb... I have a feeling this might take a while... ;)

I need a cheap roller fairlead... I smashed mine.

Midnight didn't have anything soft enough. Still looking for used first.

At 11pm starting a thread is pretty easy.... AC hardlines don't have much give...

The AC compressor is attached to the motor... lifting the motor won't help change it's relation to the motor mount. I thought about lifting the motor with the mount still attached to the frame to get the bolt to tilt, but I don't know if the bolt will go far enough to get even one side through...

2001 TJ 4.0L Swapping to some Heavy Duty motor mounts. Passenger side: no issues: easy. Driver side: the motor mount bolt threads in from the front and hits the AC compressor (right where the lines bolt to the compressor body). Is there an easy way to remove the bolt without unbolting the...

Best day ever. Need one of these. https://www.youtube.com/watch?v=VmXlrwGCUPE

SOLD!

http://www.cyclopsadventuresports.com/KTM-Husky-2014-16-Dirt-Bike-LED-Headlight-Bulb-Kit_p_127.html is it worth paying $110 to upgrade the bulb in my bike?

need some 2.5" 16" 200lb coil over coils maybe we could make a coil over trade/ swap thread.