B.a.m.f.

[tc meiser]

Update....

i just got a few pics of the bump stops in the front tell me what you think

 

[tc meiser]

this is kinda different but i thought i would throw it on there. check it out

 

[cjncustoms]

That looks freakin sweet!! You stole my idea for the dimple dyed strip between the frame and tub on the rear!!

 

[tc meiser]

yeah i have thought about it for a while i still need to clean up all the welds should look good when its all done.

 

[skykrawler]

Nice Build.. Keep it up. and keep up the posts on any updates.

 

[Bart]

Lovin it. Nice work. Smart thinking on the boat sides.

 

[suisuki]

Your Craftsmanship is outstanding, nice fab work!

Your old man's gonna have one sweet rig when ur done

 

[tc meiser]

update....

ok people my dad went through all of the wiring and totally redid all of it. he wired up everything and then we finally turned it over and it fired right up. So, we have a jeep that is now running again.

 

[tc meiser]

now with the motor running its a big step in the whole progress while my dad and one of his buddie figured out the wiring situaiton i was finishing up the front end i wanted to do something a little different witht the fenders and a little different front end, not just your same old boner bar or stinger and not even a blade i encorperated the front bumber to also be used as a fairlead there is a fairlead on the bottom of the winch to suck up the axle but just incase we need to pull any of you guys out there is a fairlead on front. HA HA HA

 

[tc meiser]

here is a few more of the front end.

 

[tc meiser]

those tube fenders were a *#*#* to build they have five compound bends and to duplicated for the other side was not fun. but i think they turned out ok. Here is a couple more pics along witht the front bumper.

 

[tc meiser]

Gotta a good pic of my dad and his buddie right after they got the engine to fire up and a few more of the front end.

 

[tc meiser]

It was a late night last night i worked on the jeep from 2 pm - 4 am we started to throw in a cage we got both sides done and wind sheild bar we will be finishing up today. check it out!!

 

[tc meiser]

heres a few more.

 

[tc meiser]

a few more....

 

[I Lean]

How well does that engine-hoist cylinder work for bending? I thought they needed to be more or less upright to work properly, but here you are using one. Work OK?

 

[tc meiser]

it works ok nothing like what we had at the shop i can do 40 degrees and bend in 60 seconds. so its not that slow and it seems to be working ok at the angle its at. The problem is the ram is so heavy its hard to support it. here is few pics of it.

 

[Herzog]

Looking GOOOOOD!

 

[tc meiser]

thanks herzog i am gonna go out and finish up the cage i will update ya'll latter. PEACE

 

[CJ Matt]

Looking good TC. Enjoy your weekend and then get back to work on mine