- Location
- Grand Junction, CO
Looking good, its almost there! What do you have planned for the grill and hood?
Krazy Ks new build.
- Thread starter kmboren
- Start date
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
- Location
- Grand Junction, CO
That's right, I forgot you already had the front clip. It's going to look amazing!
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
Stripped down and paint started. 
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
It is starting to get put back together. Chassis is all painted drivetrain is back in. Check out this sick exhaust work from Reeves off road.
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
Something fun in the works for the buggy. Will be revealed @ Cedar comp if it all comes together on time.
- Location
- South Carolina....no public land
isn't that going to be a bit hot on the feet? Maybe I'm just not clear on where the pedals will be positioned.
I've got an even worse header/foot pedal situation on the "pretty hate machine" build than he does but wrap and heat shields do quite a bit of good work!
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
Exhaust will be wrapped. There are aluminum panels that are not installed in this picture that also will block the heat. They are in this picture.
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
Lot of progress on this. We need it for our first comp at the end of the month so they have been working hard to get it finished.
Wiring and plumbing is being worked on. PSM will be under driver seat. We had to flip the intake because the motor is sitting forward because of the 4 speed atlas thus putting the air filter into the passenger area. So excited to get this into our possession.
Wiring and plumbing is being worked on. PSM will be under driver seat. We had to flip the intake because the motor is sitting forward because of the 4 speed atlas thus putting the air filter into the passenger area. So excited to get this into our possession.
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
They are pushing to get it done by next weekend, the 16th as we have friends coming into town and are wheeling that following week. Hopefully we have the buggy to wheel but if not then the YJ with our friends.
If the comp is the first time we drive it then so be it but we hope to have a little seat time first.
Wheeling the whole week? We have spring break and I’m off 20-24 and we haven’t made plans…
RockChucker
Well-Known Member
- Location
- Highland
I’ll be down yonder 20-24. Not sure what days I’ll be able to Jeep though
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
I am wheeling the 17th-20th with some on the 21st (after my kids field trip). I work the 22nd and 23rd but could probably sneak out the 24th some.
pennsylvaniaboy
Member
What width are you building the axles at?
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
The track width with 37x12.50 tires was around 82-82.5. With the 40x13.50 tires that will increase an inch so probably about 83-84 inches. 111 inch wheel base.
pennsylvaniaboy
Member
So stock width axles?
kmboren
Recovering XJ owner anonymous
- Location
- Southern Utah
Front is a High pinion 04 superduty 60 with Branik hubs and 35 spline outers with Artec truss and full hydro mount. Rear is a Sterling 10.5 with Ballistic fab Shave kit. Raceline wheels with as narrow off set as possible. 4.88 gears with air lockers.