Search results

It was from a Ford F100, it is 61.5" wide at the wheel mounting surfaces. I've got Six States looking into some bearing options.

I still have the 86 one.

If you look on the panther link for sheets 22 and 23 of the old dana 60 manual you will see what the axle looks like. I have read the complete manual and there are discussions on the powerlock posi end shaft "button" spacers and the backing plate shims.

The axle is under the jeep with all new gears, bearings, and locker so I need to fix this axle.

My son has put in a semi float dana 60 into his comanche and we discovered an issue when we installed the axle shafts. The axle came from an old F100 Ford truck that had a powerlock posi in it. It turns out that the powerlock has two axle buttons in the spider gears that push out on the axle...

It looks like my stick of DOM is still over 10 feet long so I should have enough to share some, now I need to remember what I paid for it.

I have a good one, no dents, a bit of surface rust underneath $75

That might be a bit soon as I haven't gotten it to where I can drive it yet, but it sounds fun.

Well I found the problem, there are two hose connections on the back of the EGR solenoid, one is a vent and the other controls the EGR and I had the two connections swapped. I did the test port pin short and I got the 12 code so I must have wired the maint req wire correctly. Now I need to weld...

I have some but need to measure how many feet I have. I still need to make some upper control arms for my son in law.

IT IS ALIVE !!!! I finally got everything to the point of firing up the engine and it actually came to life. I have a TBI fuel issue that I need to track down. At first I had to prime it to get it going but after a while it ran on its own but it sometimes lopes at idle and dies. The TBI is one...

I used to own a 76 TL250 and had a lot of fun with it. My mom used to ride the exact one you found.

I would never do this, the last time I saw someone who tried to tandem pull a trailer and off-road rig to Moab they ended up wrecked just before Price. Nice Toyota 4x4 rolled off the trailer, both trailers jack-knifed and messed up. The biggest mess of a tandem rig I saw in Parleys Canyon where...

I think the first one is scheduled to be swapped this Friday.

We will be swapping some dana 44s into some family XJs and will have a couple of complete 8.25 axles when we are done.

In

As Tacoma said all 205s are cast, the newer ones have a round mounting pattern rather than the older figure 8 mounting pattern.