Wow, what an intricate kit. 6lbs of screws, nuts, and bolts, 7 stepper motors, 4 fans. I bought printed parts with enough pieces to get the printer to run, but no embellishments. It is assembled, to the degree I have parts, wired, and initial smoke test (negative for smoke). I had preloaded the SD card on the Raspberry Pi and it's pretty cool to watch Linux boot in tiny little letters on the display (albeit upside down, for now). Tomorrow I'll work on getting MainSail and Klipper installed. Who knows, maybe even I'll be able to squirt some plastic.
If you squint really hard you can almost see the LED's glowing.
Bed heater is 120V 750W and is controlled by the solid state switch in the bottom left.
Top right is the raspberry pi (version 4b),
below that is the BigTreeTech Octopus 1.1,
bottom right is a breakout board for the cable to the print head and limit switches.
You can see 2 of the 4 Z-axis stepper motors to the top left and right.
The entire frame, upside down.